Measurement Chain Setup: macOS Audio I/O, Calibration, and Levels
Configure devices, sample rates, permissions, calibration, and healthy levels before you measure.
What this is for
REW cannot make valid measurements unless the audio input, output, sample rate, permissions, and levels are configured correctly. This lesson covers macOS-specific setup and general calibration/level workflows.
Concrete steps
Outputs and interpretation
| Output | What it tells you |
|---|---|
| Bottom of REW main window | Sample rate and bit depth in use. |
| Level Meters | Input and output RMS/peak levels. Healthy input is typically -30 to -12 dBFS. |
| Captured graph | Last sweep signal and uncorrected captured response. Useful for troubleshooting clipping and latency. |
| Mic/Meter Cal trace | Microphone correction curve. |
| Soundcard Cal trace | Interface correction curve. |
| SPL Meter | Calibrated SPL reading. |
| Measurement headroom | Distance from clipping. Aim for 6–40 dB. |
Worked example: Configuring a USB measurement mic on macOS
Connect a calibrated USB mic. If macOS does not prompt for microphone permission, run tccutil reset Microphone and restart REW. In Audio MIDI Setup, set the mic to 48 kHz. In REW Preferences → Soundcard, select the specific USB mic as input and the interface as output. Load the mic calibration file. If the cal file contains a Sens Factor line, REW may not need separate SPL calibration. Open Check Levels, play pink noise, and adjust output volume until the SPL meter reads about 75 dB. Verify input level is around -30 to -12 dBFS.
Common mistakes
- Leaving devices as Default Device.
- Forgetting to set the sample rate in Audio MIDI Setup.
- Expecting ASIO to appear on macOS.
- Enabling MIDI on a Mac that crashes.
- Not granting microphone permission.
- Changing sample rate without recalibrating.
- Feedback loop from Line In to output.
- Using a soundcard cal file with a USB mic.