Lesson 3
Making a Valid Sweep Measurement
Run the core REW sweep workflow correctly, choose timing references, and avoid the mistakes that corrupt comparisons.
What this is for
A valid sweep measurement is the foundation for almost every analysis in REW. It captures the transfer function and impulse response of the system at one source/mic position.
Concrete steps
0 of 12 steps completed (0%)
Outputs and interpretation
| Graph | What it tells you |
|---|---|
| SPL & Phase | Frequency and phase response. |
| Impulse | Time-domain response: direct sound, reflections, decay. |
| Captured | Last sweep signal and captured response. Useful for troubleshooting clipping and latency. |
| Measurement Info | System delay, timing reference, sample rate, calibration files. |
Worked example: Subwoofer measurement 10–200 Hz
Set Start Freq to 10 Hz and End Freq to 200 Hz. Use a 256k or 512k sweep. Set level to about 75 dB SPL. Use an acoustic timing reference if you will compare with other speakers. Choose Set t=0 at IR start for subwoofer work because the sub's peak is broad. Measure the subwoofer alone, then save.
Common mistakes
- Using different sweep levels for measurements you will compare.
- Not using a timing reference when phase/delay matters.
- Using multiple sweeps with a USB mic or separate devices.
- Clipping the input.
- Forgetting to save.
- Moving the mic between measurements.
Check your understanding
1. The sweep spans:
2. Why use a timing reference?
3. Multiple sweeps averaging is not possible with a USB mic because: