Lesson 4
SPL & Phase, Impulse, and IR Windows
Read the main frequency and time graphs, set IR windows to isolate direct sound or include room response.
What this is for
The SPL & Phase graph shows the frequency response and phase. The Impulse graph shows the time-domain response. IR windows control which part of the impulse response is used for the frequency response calculation, allowing you to separate direct sound from room effects.
Concrete steps
0 of 10 steps completed (0%)
Outputs and interpretation
| Graph | What it tells you |
|---|---|
| SPL & Phase | Magnitude and phase response. |
| Impulse | Direct sound, reflections, decay. |
| ETC | Envelope of the impulse; reflections appear as spikes. |
| Step response | Integral of windowed IR; shows time-domain behavior. |
| Window indicators | Show left/right window extents. |
| Windowed trace | Shows data used for frequency response. |
Worked example: Direct sound isolation vs room response
To isolate the direct sound of a speaker for EQ, set a short right window (e.g. 5–10 ms) and a short left window. This removes most room reflections but limits low-frequency resolution. To include room response for modal analysis, use a long right window (e.g. 500 ms or more). Observe the SPL curve change as you adjust the window.
Common mistakes
- Smoothing low-frequency measurements and hiding modal peaks.
- Using too short a right window and getting a jagged response.
- Using too long a window and including too much room.
- Ignoring phase.
- Not re-applying windows after changing settings.
Check your understanding
1. A short right window does what?
2. The minimum valid frequency for a 10 ms window is roughly:
3. FDW width varies with frequency how?